3040-00-400-0330, SHAFT,SHOULDERED

National Stock Number:
3040-00-400-0330

Federal Supply Class:
3040

National Item Identification Number:
004000330

Description:
SHAFT,SHOULDERED

Detail:
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (AA), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see AXLE(1), SHOULDERED. For items not having any of the above conditions see PIN, SHOULDER, HEADLESS. Excludes SHAFT(1), STRAIGHT; and AXLE(1), STRAIGHT.

Manufacturer Information:

532154-11	0ZWK8	MOOG MILITARY AIRCRAFT LLC
532154-11	45934	ONTIC ENGINEERING & MANUFACTURING, INC
532154-11	70210	HONEYWELL INTERNATIONAL INC.

Techincal Specification:

END SIMILARITY	NOT IDENTICAL
FIRST END DISTANCE FROM END TO GROOVE	1.190 INCHES NOMINAL
FIRST END DISTANCE FROM HOLE CENTER TO END	0.182 INCHES MINIMUM AND 0.192 INCHES MAXIMUM
FIRST END EXTERNAL THREAD LENGTH	0.620 INCHES MINIMUM AND 0.680 INCHES MAXIMUM
FIRST END SPLINE LENGTH	2.330 INCHES NOMINAL
FIRST END SPLINE MAJOR DIAMETER	0.7972 INCHES MINIMUM AND 0.8022 INCHES MAXIMUM
FIRST END SPLINE MINOR DIAMETER	0.7315 INCHES MINIMUM AND 0.7398 INCHES MAXIMUM
FIRST END STYLE	CIRCULAR GROOVED
FIRST END GROOVE WIDTH	0.6562 INCHES MINIMUM AND 0.6567 INCHES MAXIMUM
FIRST END HOLE DIAMETER	0.2100 INCHES MINIMUM AND 0.2200 INCHES MAXIMUM
FSC APPLICATION DATA	ACTUATOR,LEADING EDGE SLAT,ACFT
LARGEST STEP DIAMETER	1.040 INCHES MINIMUM AND 1.070 INCHES MAXIMUM
OVERALL LENGTH	7.320 INCHES NOMINAL
MATERIAL DOCUMENT AND CLASSIFICATION	MIL-S-6709 MIL SPEC SINGLE MATERIAL RESPONSE
MATERIAL	STEEL
SECOND END DISTANCE FROM HOLE CENTER TO END	0.182 INCHES MINIMUM AND 0.192 INCHES MAXIMUM
SECOND END EXTERNAL THREAD LENGTH	0.620 INCHES MINIMUM AND 0.680 INCHES MAXIMUM
SECOND END SPLINE LENGTH	1.085 INCHES NOMINAL
SECOND END SPLINE MAJOR DIAMETER	0.7972 INCHES MINIMUM AND 0.8022 INCHES MAXIMUM
SECOND END SPLINE MINOR DIAMETER	0.7318 INCHES MINIMUM AND 0.7398 INCHES MAXIMUM
SECOND END STYLE	SPLINED (STRAIGHT)
SECOND END HOLE DIAMETER	0.2100 INCHES MINIMUM AND 0.2200 INCHES MAXIMUM
SURFACE FINISH	32.0 MICROINCHES

Click here to Register for Free 30-day Trial