| BORE DIAMETER | 30.0 MILLIMETERS NOMINAL |
| BORE SHAPE | STRAIGHT |
| CONTACT ANGLE | 18.5 DEGREES NOMINAL |
| INNER RING WIDTH | 16.0 MILLIMETERS NOMINAL |
| INTERNAL CLEARANCE | 0.0014 INCHES MINIMUM RADIAL AND 0.0018 INCHES MAXIMUM RADIAL |
| INTERNAL FIT-UP CONTACT ANGULAR DIRECTION | PRIMARILY RADIAL |
| LOAD DIRECTION | ANGULAR |
| LUBRICATION MATERIAL DOCUMENT AND CLASSIFICATION | MIL-C-11796 MIL SPEC SINGLE MATERIAL RESPONSE |
| LUBRICATION MATERIAL | LUBRICANT |
| MATERIAL DOCUMENT AND CLASSIFICATION | AMS 6415 ASSN STD SINGLE MATERIAL RESPONSE SEPARATOR |
| MATERIAL DOCUMENT AND CLASSIFICATION | AMS 6490 ASSN STD SINGLE MATERIAL RESPONSE BALL |
| MATERIAL DOCUMENT AND CLASSIFICATION | AMS 6490 ASSN STD SINGLE MATERIAL RESPONSE INNER RING |
| MATERIAL DOCUMENT AND CLASSIFICATION | AMS 6490 ASSN STD SINGLE MATERIAL RESPONSE OUTER RING |
| MATERIAL | STEEL COMP M50 OUTER RING |
| MATERIAL | STEEL COMP M50 BALL |
| MATERIAL | STEEL COMP M50 INNER RING |
| MATERIAL | STEEL COMP 4340 SEPARATOR |
| OUTER RING WIDTH | 13.0 MILLIMETERS NOMINAL |
| OVERALL OUTSIDE DIAMETER | 55.0 MILLIMETERS NOMINAL |
| PRECIOUS MATERIAL AND LOCATION | SEPARATOR SILVER |
| PRECIOUS MATERIAL | SILVER |
| RETAINER FABRICATION METHOD | MACHINED |
| SPECIAL FEATURES | PULLER GROOVE LOCATED ON INNER RING |
| STANDARD TOLERANCE DESIGNATION | ABEC NO.5 |
| STYLE DESIGNATOR | NON-LOADING GROOVE, NON-SEPARABLE |
| SURFACE FINISH | GROUND |
| TEST DATA DOCUMENT | 73342-6889093 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |