|
|
|
National Stock Number:
5365-01-071-4323
Federal Supply Class:
5365
National Item Identification Number:
010714323
Description:
SPACER,PLATE
Detail:
A flat metal or plastic item of various peripheral shapes having a solid (not laminated) cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole having a solid rectangular cross-section use DISK, SOLID, PLAIN. For round or hexagonal items with only one hole centrally located and with the length (thickness) exceeding 25 percent of the outside diameter or distance across peripheral flats, see SPACER, SLEEVE. The thickness between the two parallel bearing surfaces must be 0.006 inch, (0.152 mm) or more for items less than 1/4 inch (6.35 mm) across the peripheral diameter, or smallest overall outside dimension, or must be 0.016 inch (0.406 mm) or more for items 1/4 inch (6.35 mm) or greater across the peripheral diameter or smallest overall outside dimension. For items with a thickness less than those indicated above, see SHIM. For items with one hole centrally located conforming to the above dimensional criteria use WASHER, FLAT or SPACER, RING as applicable. When thickness and/or outside diameter or smallest overall outside dimension is designated as a tolerance/dimension the maximum dimension will be used to determine compliance. Excludes GASKET; INSULATOR (as modified) and MOUNTING PAD, ELECTRICAL-ELECTRONIC COMPONENT.
|
Manufacturer Information:
| 3467-0515-1 | 14590 | VERIDIAN ENGINEERING INC |
|
Techincal Specification:
| BOLT HOLE QUANTITY | 4 | | HOLE DIAMETER | 0.110 INCHES MINIMUM AND 0.150 INCHES MAXIMUM | | OVERALL LENGTH | 1.410 INCHES MINIMUM AND 1.450 INCHES MAXIMUM | | OVERALL WIDTH | 0.350 INCHES MINIMUM AND 0.390 INCHES MAXIMUM | | MATERIAL DOCUMENT AND CLASSIFICATION | L-P-410 FED SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | PLASTIC POLYAMIDE | | SPECIAL FEATURES | HOLES ARE THRU THE THICKNESS DIMENSION AND ARE CENTERED ON THE SAME LINE WHICH IS 0.180 IN. FROM THE LOWER EDGE,USING THE LEFT END AS A REFERENCE POINT,THE HOLES ARE SPACED AS FOLLOWS ALONG THE LINE: 0.180,0.500,0.937,AND 1.250 IN.L ALSO,THE CENTER TWO HOLES ARE COUNTERED TO A DEPTH OF 0.125 IN. AND A DIA. OF 0.310 IN. |
|
|