|
|
|
National Stock Number:
5935-01-085-5788
Federal Supply Class:
5935
National Item Identification Number:
010855788
Description:
DUMMY CONNECTOR,RECEPTACLE
Detail:
An item specifically designed to mate with a plug connector to perform one or more special functions, such as to support a plug connector when not in use, short contacts, or open or close electrical circuits, in or on another connector. It does not have provisions for attaching a wire, cable, or contact. It is designed to mount on a panel, bulkhead, wall, or chassis. It does not include connector shells which are merely used to position a plug connector on a panel.
|
Manufacturer Information:
| M83723/61-218A | 81349 | MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | | MIL-C-83723/61 | 81349 | MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | | MIL-DTL-83723/61 | 81349 | MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M |
|
Techincal Specification:
| CENTER TO CENTER DISTANCE BETWEEN MOUNTING FACILITIES PARALLEL TO HEIGHT | 1.062 INCHES NOMINAL | | CONNECTOR LOCKING METHOD | BAYONET PIN | | DISTANCE BETWEEN CENTERLINES OF MOUNTING FACILITIES PARALLEL TO BODY WIDTH | 1.062 INCHES NOMINAL | | DISTANCE FROM MOUNTING SHOULDER TO FRONT FACE | 0.708 INCHES MINIMUM AND 0.728 INCHES MAXIMUM | | ENVIRONMENTAL PROTECTION | HUMIDITY RESISTANT AND SALT WATER RESISTANT AND SHOCK PROOF AND VIBRATION PROOF | | INSERT POSITION IN DEG | 0.0 | | MATING END QUANTITY | 1 | | OVERALL HEIGHT | 1.343 INCHES NOMINAL | | OVERALL LENGTH | 0.760 INCHES MINIMUM AND 0.800 INCHES MAXIMUM | | OVERALL WIDTH | 1.343 INCHES NOMINAL | | POLARIZATION METHOD | KEY, MULTIPLE KEY GROOVE | | SHELL MATERIAL | ALUMINUM ALLOY | | SHELL SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | MIL-A-8625,TYPE 3,CLASS 1 MIL SPEC SINGLE TREATMENT RESPONSE | | SHELL SURFACE TREATMENT | ANODIZE | | SHELL TYPE | SOLID | | SPECIFICATION/STANDARD DATA | 81349-MIL-C-83723/61 GOVERNMENT SPECIFICATION | | TEST DATA DOCUMENT | 81349-MIL-C-83723 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). | | UNTHREADED MOUNTING HOLE DIAMETER | 0.106 INCHES MINIMUM AND 0.125 INCHES MAXIMUM |
|
|