|
|
|
National Stock Number:
5955-01-084-2978
Federal Supply Class:
5955
National Item Identification Number:
010842978
Description:
CRYSTAL UNIT,QUARTZ
Detail:
An item which consists of a quartz crystal resonator(s), suitably mounted in a HOLDER, QUARTZ CRYSTAL.
|
Manufacturer Information:
| CR-161/U | 00136 | MICROSEMI CORP. - HIGH PERFORMANCE TIMING | | CR-161/U | 13571 | ELECTRONIC RESEARCH CO SUB OF Q-TECH CORP | | CR-161/U16.000000MHZ | 81349 | MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M | | MIL-C-3098/142 | 81349 | MILITARY SPECIFICATIONS PROMULGATED BY MILITARY DEPARTMENTS/AGENCIES UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M |
|
Techincal Specification:
| BODY WIDTH | 0.275 INCHES MAXIMUM | | BODY THICKNESS | 0.083 INCHES MAXIMUM | | CENTER TO CENTER DISTANCE BETWEEN TERMINALS | 0.104 INCHES MINIMUM AND 0.120 INCHES MAXIMUM | | CIRCUIT RESONANCE | SERIES RESONANCE | | DRIVE LEVEL RATING | 1.5 MILLIWATTS MINIMUM AND 2.5 MILLIWATTS MAXIMUM | | EQUIVALENT RESISTANCE VALUE IN OHMS | 75.0 MAXIMUM | | FREQUENCY TOLERANCE FOR OPERATING TEMP IN PERCENT | -0.005 TO 0.005 | | MODE OF OSCILLATION | FUNDAMENTAL | | OPERATING TEMP RANGE | -55.0 TO 125.0 CELSIUS | | OVERALL LENGTH | 0.300 INCHES MAXIMUM | | OVERALL THICKNESS | 0.102 INCHES MAXIMUM | | OVERALL WIDTH | 0.295 INCHES MAXIMUM | | SHUNT CAPACITANCE IN PICOFARADS | 7.0 MAXIMUM | | SPECIFICATION/STANDARD DATA | 81349-MIL-C-3098/142 GOVERNMENT SPECIFICATION | | SPECIFIED FREQUENCY | 16.000 MEGAHERTZ | | STYLE DESIGNATOR | OVAL BODY, WIRE LEADS | | TERMINAL LENGTH | 1.500 INCHES MINIMUM | | TERMINAL DIAMETER | 0.016 INCHES MINIMUM AND 0.019 INCHES MAXIMUM | | TEST DATA DOCUMENT | 81349-MIL-C-3098 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
|
|